The Zero Glide Replacement Nut System borrows the "zero fret" concept to reduce string contact in the nut by up to 93%, increasing tuning stability, playability, and open string tone. It only takes a few minutes to install with absolutely no permanent alteration to your instrument. For Goldtone Banjo (Drop-In).
Also available in Black Delrin.
I bought two of these, one Gibson-style and one Fender-style for two of my favorite project guitars, an Epiphone LPX and my Jazz-O-Caster parts guitar. The Gibson was a near drop-in, needing only some trimming and shaping for a perfect fit. The Fender was slightly more challenging, as the neck on the Jazz-O-Caster never saw the inside of any Fender-approved factory! It required a 1/32" shim underneath for a proper fit, and some sanding to make room for the tang. There was a marked increase in the brightness of tone for both instruments, as well as improved intonation. This is MUCH easier than installing a traditional nut, and nearly foolproof IF you follow the instructions. Thanks, Stewart-Macdonald, for stocking such a well-engineered product.
Pretty easy to install - sand it down to fit - pick the fret that matches the rest of your fretboard - couldn't be easier!
My old nut was too high. And I didn't want to buy 6 nut files. This Zero glide was much, MUCH cheaper, and it was an easy instal. I taped some 400 grit sandpaper to a plank I had laying around. Sand sand sand, check the fit, repeat. I tried each fret it came with and chose the jumbo. I consider this a major upgrade to my home built super strat.
$34.99
$34.99
$34.99