The bone nut was easy to install. I sanded the length and depth with a table sander. The instructions are complete and easy to follow. Four zero frets of different sizes are included in the banjo kit--you try the smallest and work your way up until you have no open string buzz. Use medium viscosity cyanoacrylate (available from Stewmac) so you have time to set the nut and fret properly. I'm pleased with the results, improved tone, and hammer-ons and pull-offs are more defined.
I m impressed with this. Easy to install. I m not a luthiar but I have refretted a few guitars and made some nuts and saddles. This is a pretty incredible system. I was going to cut a new nut for an acoustic guitar I just bought. I tested it and it was not sliding perfectly through the nut even though there was no ping while tuning. The way I test a nut is to strike a note then smack the string between the nut and the machine heads. behind the nut I put a tuner on the head stock so I can watch the note go up and come back. It simulates a good bend and you can watch the quality of the nut you have on the guitar. Most guitars will stick at about 6 to 10 cents above the tuned note unless you have a really well cut nut. At least the wound strings will....steel strings will usually drop back to the tuned note if the nut is decent . The nut I had on this guitar was pretty good....no pings while tuning yet it would still catch occasionally which effected tuning.
My circa 1997 American Standard Strat always had a problem with staying in tune after whammy bar use. I tried pencil graphite and different string sizes with not much luck. I put this nut on and a set of Gotoh locking tuners and now it seems to stay in tune very well.
I bought this for a Washburn Oscar Schmidt OE-40B archtop guitar, on which the nut had broken when putting on new strings. I always wanted to try a zero-fret nut and was pleasantly surprised at how well it works. Perfect string height and tone.
