ZB-25 Unslotted Replacement Nut for Resonator Guitars

Excellent product // outstanding company // amazing customer service

Jul 20, 2021

I just purchased my 3rd zero glide nut. I have one on my acoustic guitar and this is my second on my 5 string banjo. I've had a couple of custom necks built by different luthiers and in each case I went with the zero glide nut in place of a traditional bone nut. I am a believer in all the technical advantages that the zero glide has to offer. On top of being a great product the family and staff at Gold Tone Banjos are simply amazing folks. I've experienced genuine and personal assistance from everyone that I've been in contact with in the company. This goes all the way from the owner and his wife to their children and techs in the shop. After placing my 3rd order online last night I received a call first thing this morning from Justin wanting to make sure that I understood exactly how the nut slots were cut at the factory on the ZS 8 pre-slotted nuts. Justin made sure that I was 100 satisfied. The new nut was finished this morning and shipped same day. If I could give this review a 10-star review I would. Point being is that this is a top-notch company with great personal and corporate values. I give them and their products the highest review and praise possible. Most definitely recommended.

Steve Dyrda - Acworth GA

martin nut

Nov 4, 2023

Now that I have it setup I love it. The kits should have all available nut wires in it. I had to special order the largest wire for my Martin Dred kit because the included were too small.

Ken Fuehrer

A Lot Less Hassle Than Slotting.

Jun 17, 2016

Resolves the nut-string height issue with a simple and easy installation. Worked perfect on my Heritage 16.

Wayne from

An Excellent Product!

Apr 30, 2016

I bought two of these, one Gibson-style and one Fender-style for two of my favorite project guitars, an Epiphone LPX and my Jazz-O-Caster parts guitar. The Gibson was a near drop-in, needing only some trimming and shaping for a perfect fit. The Fender was slightly more challenging, as the neck on the Jazz-O-Caster never saw the inside of any Fender-approved factory! It required a 1/32" shim underneath for a proper fit, and some sanding to make room for the tang. There was a marked increase in the brightness of tone for both instruments, as well as improved intonation. This is MUCH easier than installing a traditional nut, and nearly foolproof IF you follow the instructions. Thanks, Stewart-Macdonald, for stocking such a well-engineered product.

John from