ZS-10 Slotted Replacement Nut for Mandolins

I purchased a '97 Squier Vista MusicMaster Bass locally. The stock plastic nut needed replacing or filing. I had already pulled the nut off of the MusicMaster and had all measurements noted before replacing the stock nut temporarily. The Zero Glide ZS-17F Precision Bass Precision Bass model specs matched up with the MusicMaster specs. Cool. After my Zero Glide arrived I pulled the stock nut and lightly sanded the nut slot on the fretboard with fine sandpaper to remove any debris or adhesive residue used on the stock nut. Next I slid the Zero Glide nut onto the fretboard. Nice snug fit. The width of the Zero Glide was perfect. My next step was to make sure that the top / flat surface of the nut was flush with the fretboard. This is crucial to allowing the fret to seat correctly on both the fretboard and the zero fret nut. On my MusicMaster this required a very thin shim under the Zero Glide nut. Once the nut was seated properly it was just a matter of selecting which of the fret sizes provided is required for the instrument. In my case this was the longest installation step time-wise. Once you have selected the proper fret, mark the fret and cut with the proper tool. Examine the cut end of the and correct any imperfections due to cutting on the tang of the fret by filing. A small bench top vise with padded jaws and high quality file makes this step a snap. Installation time in my case : - shimming me the nut, less than 10 minutes - selecting the correct fret size, 45 minutes - all filing on the fret ends and top corners of the nut, less than 15 minutes I'm very pleased with the results. The open string notes sound like fretted notes of course, and I was able to achieve noticeably lower action without fret buzz after a setup. I'm especially pleased with the improved note definition of the open E and A strings. I did not check the intonation with the stock nut on the 1st five or so frets before I installed the Zero Glide, but the intonation is fine on the lower frets. My order was processed and shipped promptly and Gold Tone customer service is excellent. Thanks for a great product !

My third build and first time I used the zero fret, made filing the nut slots easier. The sound is markedly clearer than the other bone nuts I've used.

I had a Zero Glide Zero Fret Nut installed on my 68 Epiphone SG Clone by the luthier who does ALL of my guitar work Scott Thompson at String Craft - here in Memphis . 1st off I have to say that this guitar is one of my go-to guitars the others being my 1964 handmade Mosrite Celebrity Prototype and an early 80 s Mexican Telecaster. Upon getting my guitar back with the new Zero Glide installed I plugged it into my 65 Blackface Deluxe Reverb with a JBL D120f and I was IMMEDIATELY blow away by the improvement in the TONE of this guitar... It was pretty good before BUT now it is piano like ... The tone blew me away not to mention the improvement in ACTION... You see I am a BIG proponent of Zero Frets due to my Mosrite which is the standard by which I judge all others but I was not ready for the massive improvement that was realized by the installation of the Zero Glide Zero Fret Nut on this guitar. I have used this guitar now on a couple of gigs and am STILL blown away. OH tun

Just put one of these on an old beater of a cheap strat-clone kit that I use to experiment with "creative" wiring. Suddenly its in tune up and down the neck and stays that way after using the trem as well. It cost half the price of the kit but it has significantly improved the value of the instrument to me. It required a little sanding of the back of the nut but nothing drastic. I dont have many dedicated luthier tools so the fret wire is not trimmed perfectly (but the look is in keeping with the overall "relic'd" appearance of the guitar). The question now becomes can I get a discount if I order these in bulk?