Speak with an Instrument Expert during business hours!
Business Hours:
Mon-Fri: 8:30am - 5:00pm
Sat-Sun: Closed
You Call, We Answer!
Chat with a real person
Email us directly
More Information
1-800-826-5482
contact@goldtone.com
Live Chat
Find A Dealer
Return Policy
Warranty Registration
Return Authorization (RA)
The Zero Glide Replacement Nut System borrows the "zero fret" concept to reduce string contact in the nut by up to 93%, increasing tuning stability, playability, and open string tone. It only takes a few minutes to install with absolutely no permanent alteration to your instrument. For Fender Style Guitar.
*The ZS-7F is designed to fit either a flat or radiused nut shelf. Leave the middle nub for flat, or sand it down for a radius.
Also available in Black Delrin.
Note: May not fit specific models. Check the sizing guide to be sure.
Resolves the nut-string height issue with a simple and easy installation. Worked perfect on my Heritage 16.
I bought two of these, one Gibson-style and one Fender-style for two of my favorite project guitars, an Epiphone LPX and my Jazz-O-Caster parts guitar. The Gibson was a near drop-in, needing only some trimming and shaping for a perfect fit. The Fender was slightly more challenging, as the neck on the Jazz-O-Caster never saw the inside of any Fender-approved factory! It required a 1/32" shim underneath for a proper fit, and some sanding to make room for the tang. There was a marked increase in the brightness of tone for both instruments, as well as improved intonation. This is MUCH easier than installing a traditional nut, and nearly foolproof IF you follow the instructions. Thanks, Stewart-Macdonald, for stocking such a well-engineered product.
Installed in a vintage Japanese Custom Shop Fender Tele. Great low action and better tuning stability. Easy install as well. Thanks for a great product.
Just put one of these on an old beater of a cheap strat-clone kit that I use to experiment with "creative" wiring. Suddenly its in tune up and down the neck and stays that way after using the trem as well. It cost half the price of the kit but it has significantly improved the value of the instrument to me. It required a little sanding of the back of the nut but nothing drastic. I dont have many dedicated luthier tools so the fret wire is not trimmed perfectly (but the look is in keeping with the overall "relic'd" appearance of the guitar). The question now becomes can I get a discount if I order these in bulk?
