ZS-20 Slotted Replacement Nut for 12-string Guitars

I just installed a Zero Glide Nut on my '14 Les Paul Studio. I was having trouble with the traditional *tink* and tuning issues often associated with Gibsons. Initially, I was going to try the new titanium nut made by Gibson but was told that it would not fit my '14 Les Paul. Keep in mind, I have never installed a nut before on a guitar where I needed to remove the old one. I had only fixed broken nuts in the past. I say this because I had a little anxiety when I decided to install the nut myself. The first thing I noticed was how much extra material must be sanded to get a perfect fit. For my application, I had to sand the bottom of the nut as well to get the fret to seat properly against the fret board. This may sound bad, but it is a good thing! It means that the folks at Stew-Mac realize (as I hope you do) that although these are precision instruments, there are many parts that are finished out by hand. The extra material allows for those minor variations and with a little work,

I installed this on an old Alvarez acoustic that used to belong to my Dad. The strings had started to buzz badly and the bridge height was maxed out so I knew it must be the nut. Took about an hour to cut down the new nut and shape with the Drexel tool; sided/polished the frets and installed glide nut with the tallest feet wire. Worked like a charm and no more buzzing. Even lowed the bridge down to a reasonable height as well. Great product and easy to install.

I put one on my Taylor 12 fret, it made a big improvement in string tone, tuning, and intonation. I'm now going to install them on all my guitars.

I purchased a '97 Squier Vista MusicMaster Bass locally. The stock plastic nut needed replacing or filing. I had already pulled the nut off of the MusicMaster and had all measurements noted before replacing the stock nut temporarily. The Zero Glide ZS-17F Precision Bass Precision Bass model specs matched up with the MusicMaster specs. Cool. After my Zero Glide arrived I pulled the stock nut and lightly sanded the nut slot on the fretboard with fine sandpaper to remove any debris or adhesive residue used on the stock nut. Next I slid the Zero Glide nut onto the fretboard. Nice snug fit. The width of the Zero Glide was perfect. My next step was to make sure that the top / flat surface of the nut was flush with the fretboard. This is crucial to allowing the fret to seat correctly on both the fretboard and the zero fret nut. On my MusicMaster this required a very thin shim under the Zero Glide nut. Once the nut was seated properly it was just a matter of selecting which of the fret sizes provided is required for the instrument. In my case this was the longest installation step time-wise. Once you have selected the proper fret, mark the fret and cut with the proper tool. Examine the cut end of the and correct any imperfections due to cutting on the tang of the fret by filing. A small bench top vise with padded jaws and high quality file makes this step a snap. Installation time in my case : - shimming me the nut, less than 10 minutes - selecting the correct fret size, 45 minutes - all filing on the fret ends and top corners of the nut, less than 15 minutes I'm very pleased with the results. The open string notes sound like fretted notes of course, and I was able to achieve noticeably lower action without fret buzz after a setup. I'm especially pleased with the improved note definition of the open E and A strings. I did not check the intonation with the stock nut on the 1st five or so frets before I installed the Zero Glide, but the intonation is fine on the lower frets. My order was processed and shipped promptly and Gold Tone customer service is excellent. Thanks for a great product !